How To: Installing the EZ-PULL Clutch Lever Assembly
Posted by Elite Mototech Support on Jul 19th 2024
The Elite EZ-PULL Clutch Lever Assembly is a precision lever system designed to fit tight and snug next to your bikes left "Switch Housing".
***There cannot be a gap between the control switch housing and the perch. If there is a gap, on most models the safety neutral switch and lever will not engage if the gap is present. (See Figure 1)
If the gap persist after loosening the perch cap and pushing the perch closer to the switch housing. Check to see if on the bottom inside of the switch housing to see if there is a small plastic alignment tab protruding out of the switch housing. (See Figure 2)
Trim off the alignment tab as it is no longer needed.
After removal of the alignment tab, the perch housing should be able to now fit flush with the switch housing. (See Figure 3)
Cable Adjustment
Use the cables adjustment to remove any play as the lever needs to make full use of the space between the grip and the lever. *Note: Large thick grips reduce the space needed for full motion range of the lever. Should also not require any adjustment at the clutch...cable only.